Wiring A Hanging Lamp. Check the supply wires for fraying or damage. Varying the length or height of a hanging light fixture.
Reassemble the socket shell around the socket. Web hot and neutral electrical paths in a lamp switch and socket. Your wire must be at least six inches longer.
Web 3, the next thing to do is to pinch the thread. We will do this by taking apart the old one. Web as i disassembled the hardware to get to the cord (as well as remove the heavy decorative bar that would make it hang down too low), the ground wire came off.
Reassemble the socket shell around the socket. Measure the entire length of your lamp, including any chain or tubing. Check the supply wires for fraying or damage.
After finding the line with small pliers or use small shears to pinch off the skin of the wire to reveal a longer copper wire. The hot path for electricity should run through the narrow plug prong at the wall outlet to the hot. Prep the cord for wiring by stripping 5/8 insulation off, fanning.
Lift the fixture base to the ceiling, then use wire nuts to connect each pigtail wire on the lamp base to the same color wire coming out of the ceiling box. After dismantling, thread the new cord through the plug’s. Web the two lamp cord wires on many hanging light fixtures are hard to tell apart.
Attaching a new cord plug. Web unscrew the plug screws and remove the prong insert. Thread the fixture's mounting stem into the mounting strap on the ceiling junction box.
